[elvis]

Hi all, im a straight up virgin on this site so i figure i will start with some good questions. I bought an sn60 kit for my carbed fox body project car. im am asking questions in this section because i think you guys will have my answers. I am looking for instructions to put this kit on an older pre emitions car. I am missing the paxton fuel pump and found a thread on how to mod other ones to make them work. I didnt find one on carb mods. I have an early kit made for the 1985 mustang and as far as i can tell it is the same as the old ones made for the gt 350. So if you have instructions or know about how to set up a carb for it let me know.
Thanks a ton

[Sore Pancake]

Welcome to AFM!

[andrewmp6]

You need a blower box or blow through carb for it.

[elvis]

Yes I have the blower box. But the directions I have are only to set up a stock carb and are very vauge. Most of the holes in the box are plugged from the last owner so I am thinking that some of the vac lines dont need to be hooked up.

[andrewmp6]

Talk to a good engine builder close to you see what they will tell you even if you have to pay them a little.