Replacing 1969 Motor Mount

bigtoenails · 07-31-2005

I am new to this so I hope I am doing this correctly. I have a 69 Mustang wiht a 302 engine. I am needing to replace the motor mount on the driver side. I have a Mustang book that helps with repair, but thre is nothing in there about it. I was wondering if anyone knew of a place i could go to get instructions to properly replace the mount? Thank you in advance.

Veronica · 08-02-2005

Hello.Welcome.

You need to support the engine from above with an engine hoist or a suitable substitute but after that it's just unbolt the old one and install the new one.I always replace both when I do one.I figure if one (normally the D/S) fails then the other is not far behind,so since I'm there anyway I might as well.But that's just me.Hope that helps.

bigtoenails · 08-03-2005

thank you very much for yoru help. i greatly appreciate it.