Ford Mustang Forum banner

Bench testing 1966 wiper motor

5K views 1 reply 2 participants last post by  K4JOE Joe 
#1 ·
  • I want to bench test my 1966 2 speed wiper motor (factory) before I re-install. I just want to check the motor- NOT the switch. I will connect the motor directly to a 12v battery- (no switch). The wiper motor is fully removed from the car and on the work bench. What wires do I connect to a battery to check both high and low motor speeds? Are there and jumpers needed (the green wires?)
thanks
bravoman
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top