Well went to the track last week, first time there since i purchased a sct x3 and my first run i ran a 13.613 @ 101.2 mph. My previoust best was a 13.667@ 101.04. I ended up backing it with a 13.611 and then a 13.520@ 101.83 so i was pretty happy. This is all with the canned 93 octane sct tune.
My 60' was 1.978
330'- 5.634
1/8mi- 8.689@ 80.78
1000'- 11.303
Didnt add any, just used the canned tune settings and bumped the rev limit to 6200. Kinda afraid to play with the spark, any suggestions on what to bump it to?
2002 GT 5speed roush body kit with saleen s281 three piece rear wing totone black top red bottom fr500 nitto 555 275/35/18 with Eibach pro damper system BBK cai,BBK under drive pulleys,Headmen long tube headers,BBK off road X pipe,flowmaster 80 inlet and outlet same end so the roush side exit works,roush lower control arms roush sub frame connectors brenspeed x3 zex nos 125 shot hp257 tq295 on motor 380hp and 395tq on spray best 1/4 time now 12.770 at 115 with blowin the tires of in 2nd and 3d
Well went to the track last week, first time there since i purchased a sct x3 and my first run i ran a 13.613 @ 101.2 mph. My previoust best was a 13.667@ 101.04. I ended up backing it with a 13.611 and then a 13.520@ 101.83 so i was pretty happy. This is all with the canned 93 octane sct tune.
My 60' was 1.978
330'- 5.634
1/8mi- 8.689@ 80.78
1000'- 11.303
Dan
You could get better numbers if you took it to get it dynoed. All motors are different and a canned tune may not be tapping into your cars potential......
Cravens- im running 315/35/17 nitto nt555 dr's set at around 17lbs. I went back last wed after replacing a bad coil and my trap speeds were up almost 2.5mph. I ran a best of 13.502 @ 104.09 and a worst of 13.612 @ 103.4. I dont think the track was prepped to well as all my 60's were over 2sec(at least thats the excuse im using)so i think i couldve gone maybe a 13.3!Gonna replace the plugs soon, i checked one and it was eroded as hell. I do have 93,xxx miles on her.The gap was almost .075, so im sure im losing a little there !
Ive been thinking about dyno tuning but will prob wait till next year.
hey man, a while ago you replied to a post i made about an abs sensor on an 01 gt. i was wondering if i could get those pin numbers and resistance numbers you were talking about. i was trying to send you a pm but couldnt get it to work so this was the best way i could find to contact you. thanks in advance for any info you can give me.
New 1/4mi time! 
