Ford Mustang Forum banner

quick tip when changing rear bumpstops.

914 views 0 replies 1 participant last post by  Blackpenguin69 
#1 ·
I figured out a better way to get the eibach rear bump stops on. CJponyparts says to drill the hole bigger. When i tried that the hole just stretched to fit the bit and didnt cut the bumpstop at all.

So, This is what i did and it was way quicker than trying to cut the bumpstop. Use some wd-40 and get the bumpstop on until the head of the shock pokes through. Then get a wrench and old the tip of the the shock while turning the bump stop and pulling down at the same time. Your basically screwing on the bump stop and holding the shock from turning with the wrench. Adjustable wrench is what i used.

hope this helps somebody before they stress out and break something.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top