[89 cobra coupe]

hello everyone
new to the mustang forum, i'm building a 1989 mustang coupe will have pictures on completion. i'm converting from 4 lug to 5 lug and my question is ? do i need to use V/8 spindles , when using the rotors off of a 1988 ranger or will the 4 cylinder spindles work !!!thanks for all help.
DAN

[stlwagon]

Welcome aboard... Let's find you an answer in here.

[RLG34750]

Originally Posted by 89 cobra coupe

hello everyone
new to the mustang forum, i'm building a 1989 mustang coupe will have pictures on completion. i'm converting from 4 lug to 5 lug and my question is ? do i need to use V/8 spindles , when using the rotors off of a 1988 ranger or will the 4 cylinder spindles work !!!thanks for all help.
DAN

Welcome to the site.....

and here's hopefully the answer to you question....

For the front you will need one each left and right side spindles, hubs, rotors and calipers from either a '94 or '95 V6 or V8 Mustang. The assemblies are the same for the V6 and V8 so either will work but it must be from a '94 or '95. This is because the spindle was moved out about ¼" - ½" on the '96 and later Mustangs. This will cause the wheel to stick out too far and possibly cause interference problems with the wheel well lip on the fender.