As expressed in the Gui Pro


Thanks!

[GTRaptor]

Have you tried on the Yahoo group?.....i cant find them damnit.

OR...do you have the slopes on the EECTuner software?

All you need to do is save the SLopes using the EECTuner sw, then READ ROM and read it with the GUI. It will translate the slopes to GUI values.

SAMPLE for EECTUNER:

ZAO
LOW_INJ_SLOPE 36
HIGH_INJ_SLOPE 36
END

Upload to TUNER + READ ROM, then OPEN the BIN on GUI

I use the GUI only but hate how everything is different in times like this

Thanks Ron


Ian

How about if I had 50lb injectors and the maf set for them what do I ,or how do I put the values in the maf function on the eec program?

[GTRaptor]

PRO-M Mafs are calibrated with different voltages than stock MAS sensors. The thing to do here is to plot the PROM sheet using both VOLT and AIR into the MAF table.

If you have a STOCK maf sensor, ditch the PROM sensor and install the stock one into the PROM housing. Then you keep the stock voltages and use only air flow values from the proM sheet.

Injector size will then be set into the HIGH and LOW Slopes for 50lbs injectors.

I found that with the GUI, the value is expressed in seconds no minutes so you just divide the regular slope value by 3600. Ei: 36/3600= 0.0100 ect