[stangmanok]

Ok. I finally got my 24# installed, and I"m about to tune with the EEC-Tuner. What should I set my high and low slope values too. I'm running stock MAF for 19#.


Thanks!!

[stangmanok]

NM. I set as follows.

LOW_INJECTOR_SLOPE 29.8074# Low Injector slope lbs/hr
HIGH_INJECTOR_SLOPE 24.8395 # High Injector slope lbs/hr

That did help my part throttle miss alot, but it's still there. I guess I may drop the $130 on some o2 sensors and try that, but I hate to throw the money away if mine are fine.

[bhoffman67]

Since you changed your injectors from 19# to 24# but (presumably) haven't adjusted your MAF_FUNCTION, do that next. Keep in mind that you've increased fuel metering by 26% but not the corresponding MAF. You'd be pretty safe starting by raising all your data points in the MAF_FUNCTION by 23%, then see where you're at from there.

[stangmanok]

I've already made a new MAF function. I ended up raising the values by 2% all the way to 15% lean. I am running a MAF calibrated for 30#, and I'm running 24% injectors.