[adabiri2]

How do you correctly install studs for intake/carb?

How do you torque the stud.

[heavy metal]

just screw them in tight,use a little loctite.

[adabiri2]

Put the bolt on and torque to specs.

OR

Use the "stud puller" tool to put them in. Or is that for just taking out?

[93 white fox]

A studd puller is made to pull out the studds. Just add a little loctite and tighten by hand. Ps: not to tight you may damadge your carburetter's base

[ttopstang]

find 2 nuts that fit it and tighten them back to back, then you will be able to get the stud down as far as you need . i wouldnt recomend tightening by hand, i did that with my intake and used loctite and it still came loose.

[EagleAutosports]

The studs should come with instructions on proper installation.