[JerseyStallion]

I'm trying to figure out how to boost my 2005 V6's Hp and torque without killing my funds. I already put in a high performance flow tube and a JBL exhaust system, any suggestions???

[05horse]

im running 240.8 HP
dyno

flowmaster duals
kn filter( made a ram air intake for it myself(airboxmodification))
upped the voltage. aded rear end gears all for under $1000 ofcorse i did the work myself sept putting in the gears

[shinerstang]

Most also go with nitrous. It is a safe power adder if you get a proper dynotune......

[JerseyStallion]

I was thinking Nitrous, but whats a good kit for the V6 and how hard is it to self install?

[shinerstang]

They are not very hard to install at all if you have some mech. knowledge. All the kits are about the same as far as performance. It's mostly tapping into power, tps, and adding the fuel line on your shrader valve on the fuel rail. I have an rpm window switch so it takes the guesswork out of when it's going to kick on/off.

Just get a good tune......

[JerseyStallion]

oh ok so its sounds enough to do. what are the chances that I blow my block with it though???

[shinerstang]

A good dynotuner takes away almost all of the risks. You just don't want to run lean on the juice......

You will also need 1 step colder plugs on a 75 shot......