Quote:
Originally Posted by Notch Nightmare  I have a 1989 Mustang and im building a 331 stroker, and im also going to install a Vortec V-2 SQ trim supercharger and my question is im putting a Canton 7 qt. oil pan with crank scraper and windage tray and so im a little querious on where i need to tap the oil pan for the blower oil return line. Does it get tapped in the same exact spot as the stock pan? but now it has a different pan with scraper and the bottom end of block has windage tray will the interfear with where i need to tap pan. Im in need of help with anyone that may have some information or experience with this set up will be appricated! |
Trying to tap an oil pan is like eating a soup sandwich, I took a peice of 1/4 thick 2 inch square peice of steel drilled a hole in it for the oil return line then welded the bung to the 2 inch square plate.
Use the drilled plate as a templete and mark your pan, drill the return hole through the pan. I then made a gasket to fit between the plate and oil pan and used self tapping 1/4 inch bolts to go through the oil pan, no leaks and the return works fine, as far as location pick a spot up high on the oil pan nothing sticking through so it wont touch nothing or be in the way.....
Need Help Tapping Oil Pan for Supercharger Return Line 
