[vr4_007]

Just picked up a 1.5KB for my 1991 GT Mustang and was curious what all I needed to run the larger of the two pulleys? I'm pretty sure its a 6-8# pulley. Does anyone know if a stock setup (fuel pump, injectors and Maf) will be enough for the Kenne Bell?

Also, any pointers I should know about as I go into the install?

[jaja6009]

Did you buy this used or new? I thought they didnt offer a 1.5 kit anymore. If its used make sure you have all of the parts like bracket for air conditioner and so.
The following is just my opinion.
Use 24 or 30lb injectors.
Use a 155 or 190 fuel pump.
Use a bypass valve if it didnt come with one.
Get a custom dyno tune to correct timing and a/f ratio and have a chip burnt.
If not getting a dyno tune you will need something to retard your timing.
You can get bigger MAF and throttle body but they are not needed but will add power.
I would get a dyno tune.

[vr4_007]

Thanks,..

Just looking for some confirmation as to weather or not the 1.5 can be used with stock components such as injectors, MAF and pumps.

Should i just up the fuel pressure?