Zex nitrous install

Bunky · 07-15-2003

Since the directions in the kit are not what they should be.
I was wondering if any one could help ? 95 5.0 mustang
Looking to find out which wire to tap into on the TPS sensor ? Nmae of the wire and the color of the wire.
The ones i have seen are labeled ,
SIG , Maybe for signal ?
GND , for Ground?
VERF, For variable reference ?
Please let me know how off i am .
Also what plugs are recomended and the gap.
Last but not least if there are any hints, extras, comments,
Thanks and hope to hear from someone soon.
Bunky Sr.

Julian Moore · 07-15-2003

This is a link to a write up my frind did on the Zex install on his car...I think it will help. If I remember, the wire is white? I'll call some people and get back to you. The link talks about plugs an dother stuff.
Jules
ZEX INSTALL

Julian Moore · 07-15-2003

This is a link to a writeup my frind did on th eZex install oin his car...I think it will help.
Jules
ZEX INSTALL

95mustanglover · 07-17-2003

will it burn my rings or blow my pistons?
will car last more than 12 months b4 engine rebuild if i run it once a week?

95mustanglover · 07-17-2003

i am real nervous to hit it i want this car last alittle b4 rebuild

Bunky · 07-20-2003

As long as you have checked your air / fuel ratio and made sure your timing is set for your application shot . Your engine should be ok.
As of the spark plugs make sure you are running a colder plug and gap it according to what you also have coil and ignition done.
But again if you are still unsure you shold take it somewhere you have seen nos put on .
Any thing else ?
Bunky

Crash! · 08-05-2003

SIG- Signal voltage (Variable, based on TP).
VREF- Voltage Reference (5v)
GND- Ground