[yfz162]

Anyone have any idea what length of belt i should be using??? I have a 96 cobra with a Vortech V1 running a 2.75" pulley, all accessories with factory pullies and the crank pulley is 6.75". Anyone running a similar set up? My belt shredded today and i have no idea what length it was.......

[dtuna42]

Since nobody with more Vortech experience answered up I will try to help...

I think your best bet would be to contact Vortech directly, eith through website or tech support phone...

or

If you you know - or can figure out - which way the belt wraps around all of your pulleys, you can do it with string. I would say you should start with any adjustable pulleys in the "middle" position so that after you get a length you can go to parts counter knowing you have a little room to play with either way. Then just wrap a string around them- start up top in an easily accessable spot and tape one end of the string to a pulley. Follow around, over, under, etc.. each pulley until you get back where you started - measure the length of string with a tape measure - and you should be pretty close is not exact..

But I would only try this if Vortech can't help with the actual name and part number of the exact belt for your car.