[evendal]

Looking for any information on where to install a mechanical aftermarket water temp phrobe on a 1.7L KB intake. There doesn't seem to be any way of combining the aftermarket with the stock sensor by using the same threaded hole provided.

Thanks

[hotwheels]

you are going to have to use one or the other...........can't use both unless you can find a way to use some brass fittings and build some type of a T...................hotwheels of insanemustangs.com

[evendal]

I got it! I have the stock sensor hooked up to the designated port in the KB intake and the ford racing mechanical water temp probe is installed in the block on the drives side where the drain plug is just below the headers. Had to be careful routing the line so not to tough the exhaust but both are working great.

[hotwheels]

awesome man..................awesome

hotwheels of insanemustangs.com