Would drilling holes for hood pins on a fiberglass hood crack it? Also, has anyone had problems lining up there stalker front bumper to their fox mustang? I ordered mine from cervinis, but it won't align right.
no i have done it but make sure they are in right place to start with
Go Slow While Drilling And Dont Push Hard Take Ur Time
Dont Over Tighten Screws That Holds Pins To Hood Cause If U Strip The Fiberglass Ur Out Of Luck Just Hand Tight Screws With Small Screw Driver
__________________
1995 Mustang GT 5.0 HO
Mods: March Under Drive Pulleys, BBK CAI, MAC Full Length Headers & Hi-Flow H-Pipe With Cats, Flow Master 2 Chambers, BBK Caster/Camber Plates, Ebiach Sportline Springs , KYB Gas Adjust Shocks & struts, K&N Filter Charger, 180 degree thermostat, 3:73 FMS, Catapult Trailing Arms, BBK 255Lbph And Adjustable Regulator, Gripp Subframes, Cobra RR Hood, Red Top Battery, Pro 5.0 Shifter, Zex 75 Shot System, 1/4 Inch Wheel Spacers Rear, M&M 6 Point Cage
Plans Stroke It And
when u buy after market stuff sometimes it wont line up right then u just have to fix it
i have seen and heard of many a hood not fitting right if its to small its a problem to big just get it trimmed down when they paint shouldnt cost that much more to have them do it i think to trim paint align my hood to my car would have been $450 i just opted to have it painted and me do any aligning and trimming so i only paid $300 to paint it 2 stage paint
__________________
1995 Mustang GT 5.0 HO
Mods: March Under Drive Pulleys, BBK CAI, MAC Full Length Headers & Hi-Flow H-Pipe With Cats, Flow Master 2 Chambers, BBK Caster/Camber Plates, Ebiach Sportline Springs , KYB Gas Adjust Shocks & struts, K&N Filter Charger, 180 degree thermostat, 3:73 FMS, Catapult Trailing Arms, BBK 255Lbph And Adjustable Regulator, Gripp Subframes, Cobra RR Hood, Red Top Battery, Pro 5.0 Shifter, Zex 75 Shot System, 1/4 Inch Wheel Spacers Rear, M&M 6 Point Cage
Plans Stroke It And
Hood pins and stalker bumper question 
Stroke It And
