Ford Mustang Forum banner

SC 4.6 wideband gauge !

1K views 1 reply 2 participants last post by  TJ91LX 
#1 ·
Hi guys! I am clueless right now!! I have a 05 GT supercharged ( edelbrock e force) and my car is running too rich! I just bought a air fuel gauge that I will install before going to get it tuned properly !

Here's the problem : On the instruction, they say to weld the boss for the oxygen sensor of the gauge at 18 inch of the exhaust port. If there's a supercharger, they say at 36 inches but BEFORE the cats. They say to install the sensor before the cats. The problem is I have the stock exhaust system... so the cats are very close to the exhaust manifold !! even 18 inches goes right in the middle of the cats, 36 inches goes after the cats !

any suggestion on what to do with that?

thanks!!!!
 
#2 ·
Get it as far down the pipe as possible,thats the best you can do right now.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top