[seal/sac15]

What are my intake options if I go with PI heads. and can you do anything to convert the stock 1998 heads to use a better intake to increase the power to 1998 cobra standards?

[EagleAutosports]

Hiya, welcome to the site. Check out the 4.6 and the SVT Cobra sections, we should have that info in there.

[heavy metal]

Welcome to the site,enjoy!!!!

[1mach1]

Welcome to AFM! Good luck!

[97 svt cobra]

if you go with pi heads you can use pi intake or buy p-51 intake($1500) or you can just run pi intake on your stock heads.best bang for your buck is pi heads and intake.it wont be cobra but you will pick up 40-50hp for about &1100-$1200

[cmaurer1]

Doing a PI swap as well as full bolt-ons will put you around a stock Cobra but you will be faster down low. The 96-98 Cobra's powerband was designed for a higher end power rather than low end power.

You will probably be at 260-270rwhp with a PI swap and full bolt-ons on your GT if you went that route. That is about what the stock Cobra's dyno at but they do pull pretty hard up top too.

[STSVT]

stock 4.6 PI motors are rated at 260hp at the flywheel.