Can someone tell me what to do to get rid of the deceration popping sounds from the exhaust?
I recently had 2.81 pulley, steeda cold air, x3 tune,heat exchanger,also I expected to feel more hp ,but not much different from stock.
Also I have the flowmaster catback system.
that is more than likely a rich condition, the unburned gas is popping in the exhaust...I'd recheck that tune, esp the fuel pressure and timing and the 02 sensors...good luck
__________________
"Goose, Hollywood's fine, I want Viper"
1995 Mustang GT Cnv 347(427 stroker being built!) almost done!
1996 Cobra with Kenne Bell 2.1 Supercharger and every other conceivable part you can bolt on it...650hp upgrade in the works
2003 Infiniti M45 V8 340 hp...a methadone treatment for reformed Mustang drivers
Can someone tell me what to do to get rid of the deceration popping sounds from the exhaust?
I recently had 2.81 pulley, steeda cold air, x3 tune,heat exchanger,also I expected to feel more hp ,but not much different from stock.
Also I have the flowmaster catback system.
more hp from what original setup? do you have cats? every mustang i've ever heard pops at one time or another - popping and a small backfiring sound is different. if it wasn't doing it before all the changes, go get your tune rechecked
that is more than likely a rich condition, the unburned gas is popping in the exhaust...I'd recheck that tune, esp the fuel pressure and timing and the 02 sensors...good luck
that is more than likely a rich condition, the unburned gas is popping in the exhaust...I'd recheck that tune, esp the fuel pressure and timing and the 02 sensors...good luck
Is there a setting on the x3 tuner that I can look for to reset?
that is more than likely a rich condition, the unburned gas is popping in the exhaust...I'd recheck that tune, esp the fuel pressure and timing and the 02 sensors...good luck
You know what, now that I think of it mine used to pop allot under deceleration in gear. Since the tune, it no longer does it. Ha! I never noticed, rofl.
__________________
C&L 80mm mass air and True Flow pipe, Mac CAI, BBK 65mm tb, Steeda non-piggy back ud pulleys, MGW shifter, RAM HD clutch and aluminum flywheel, 3:73 gears, 2.5" Dynomax o/r x pipe, 3" MAC cat back system w/ 3 1/2" tips, Kenny Brown(front and rear strut tower brace, caster plates, subframe connectors,extreme matrix brace,jacking rails, torque brace, lowering springs), Bilstein shocks, 03-04 Cobra(side scoops, rear bumper cover, top), 6pt roll cage, white FR500's, FMS 2000 Cobra R air dam.
deceleration popping 
