[edb2007]

OK!

Ive been planning on putting a SC motor in my mustang for years now, and i finally have a income to stert the project. My original plan was to get the block and build up from there. If i have it tore apart that far I'm going to replace parts with aftermarket parts. Does anyone have any reccomendations to what parts are good, strong parts for the 1995 3.8l v6?

I Need:

Crankshaft
Rods
Pistons
Cam
Valve Springs
Roller Rockers
Pushrods


Anyone know where to get performance parts for this project?

[Janstang]

I'd go to NAPA and talk to them, someone there should be able to help you. good luck.
Janstang

[thomasusmc]

take a look at this thread - http://www.allfordmustangs.com/forum...ech-sites.html

It's from the parts/tech thread at the top of the page.

You'll have a lot of things to look at and price out.

I don't know what your budget is, but I've been told these guys have some good engine Super Six Motorsports

[shinerstang]

Send GT-EATER an email. He has some good connections on where to get them.

[GT-EATER]

You can contact Tom Yentzer tyentzer@bellsouth.net or you can call him at 1-478-256-7766 tell him Gary sent you .

You can also contact Matt at Delk performance

1-615-453-2300 again tell matt that I sent you

Be prepared in advance to talk about your set up ,what you goals are and how much HP you plan to make .

[junkyardsheep]

I am also looking to make the super coupe swap into my 1994 v6 mustang.

From what I have found some of the best websites for super coupe performance parts would be www.supercoupeperformance.com and www.supersixmotorsports.com

super six offers forged internals and super coupe performance offers cams from comp cams stages II and III, roller rockers, headers, and many others parts such as jackshaft pulleys for your supercharger.