Hi guys,
I just installed a new cabin filter which was a PITA to remove. When I was removing the filter, the cowl was stuck in one piece (I wasn't aware that it splits in the middle). When I was monkeying w/ it to reinstall, I may have put more pressure on the cowl and it split in two pieces which gave me a little more room.
I pushed the cowl back down after installing the filter and I noticed before putting the pins/screws back in that the cowl wasn't seated against the windshield as snug as it was before. There are some slight gaps which I know will trap those damn pine needles.
Did I miss a step? Was I supposed to smack it back into place somewhere?
THANKS!
I just installed a new cabin filter which was a PITA to remove. When I was removing the filter, the cowl was stuck in one piece (I wasn't aware that it splits in the middle). When I was monkeying w/ it to reinstall, I may have put more pressure on the cowl and it split in two pieces which gave me a little more room.
I pushed the cowl back down after installing the filter and I noticed before putting the pins/screws back in that the cowl wasn't seated against the windshield as snug as it was before. There are some slight gaps which I know will trap those damn pine needles.
Did I miss a step? Was I supposed to smack it back into place somewhere?
THANKS!