Did re-calibrate the actuators?
The purpose of the module actuator position calibration is to allow the HVAC module to reinitialize and calibrate the actuator stop points. To carry
out calibration, carry out the following steps.
Remove Smart Junction Box (SJB) fuse 15 for at least one minute.
When the ignition switch is switched to the ON position, the HVAC module will initialize and calibrate the actuators. Calibration of the actuators will
take approximately 30 seconds.
Reinstall SJB fuse 15. Turn the ignition switch to the ON position and wait 30 seconds before verifying correct operation.
2006 GT- Airaid Race CAI, 62mm BBK TB, SR Performance UD Pullies, FRPP Hot Rod Cams, CMDP's, Excedy Stage One Clutch and lightweight flywheel, Pacesetter Long Tube Headers with matching O/R H-Pipe & MBRP Street Axlebacks, Lito 91 Octane Tune