Ford Mustang Forum - View Single Post - Lowering Kits for V6 stang
View Single Post
post #5 of (permalink) Old 05-02-2006
SHELBY GT 500 Member
V6 Member
kscoyote's Avatar
Joined: Aug 2002
Location: Topeka
Posts: 11,432
Re: Lowering Kits for V6 stang

Originally Posted by tex117
generally the lower the better it handles; and your right going down 2 inches would make it a ***** over any kind of bump or ramp. So if it were me I would go with 1.5" drop, Eibach makes good kits. FYI the kits that drop the front more than the back dont make your handling worse they just dont make it as good as an equal drop.
Actually, unless you change the K-Member, going lower than 1.5" will harm your handling, since the roll center is already below the surface of the road while the rear is above.

A lot of the cheaper springs will sack out, so look for Ford Racing, Steeda, Griggs, Maximum Motorsports, Eibach, KW, H&R, etc type of springs.

Woe to him who builds his palace by unrighteousness,his upper rooms by injustice,making his countrymen work for nothing...Does it make you a king to have more and more cedar?Did not your father have food and drink?He did what was right and just,so all went well with him. He defended the cause of the poor and needy,and so all went well...But your eyes and your heart are set only on dishonest gain,on shedding innocent blood and on oppression and extortion. Jer 22:13, 15-17
kscoyote is offline  
For the best viewing experience please update your browser to Google Chrome