Ford Mustang Forum - View Single Post - New parts for the pony!
View Single Post
post #7 of (permalink) Old 06-05-2014
Site Sponsor
AMWill's Avatar
Joined: Apr 2012
Location: Malvern,
Posts: 1,817
You should be able to use the factory dowel pins in the stock flywheel. I don't see why you would need aftermarket dowel pins for this install job. Looking at the hardware included on the site, it doesn't seem like Exedy provides them either.

To be honest, I've never performed a clutch install on an 11-14 GT. I've installed clutches on tones of New Edge Mustangs, and one 05-09 GT, but never did I need to replace the down pins in the flywheel. I don't see why the 11-14 GT's would be any different here.

Did you have your stock flywheel resurfaced? If so, I'm wondering if the tech pulled the stock dowel pins out to resurface the clutch and misplaced or lost them?

I'll contact some guys here or friends that have particularly installed an Exedy clutch onto a 11-14 GT to double check, but I have a strong feeling these guys are pulling your chain a little here.


Will Levantovsky |
Toll Free: 866.727.1266 | M-F 9AM-9PM EST | Sat 9AM-5:30PM EST
Bama Hotline: 888.226.9764 | M-F 9AM-5:30PM EST
Free Same-Day Shipping!
AMWill is offline  
For the best viewing experience please update your browser to Google Chrome