Ford Mustang Forum - View Single Post - Got a baseline dyno run in today
View Single Post
post #5 of (permalink) Old 06-27-2014 Thread Starter
MelloStang2010
PONY Member
 
MelloStang2010's Avatar
 
Joined: Aug 2013
Location: Boise
Posts: 293
 
Quote:
Originally Posted by matthewr87 View Post
Torque numbers seem a bit low but the HP numbers are pretty good. Why didn't you pull in 5th gear?
I did feel as though torque numbers were low but every dyno reads differently from what I understand. The whole key to this is that I will be using the same dyno throughout the process of modding my gt that way I'll be able to hopefully see the actual worth of my mods. As for the gear pull the instructed me to row through the gears smoothly, get to 4th and hold at 2000 rpms and then hammer it. This was my first time ever dynoing my car


Sent from AutoGuide.com Free App

2011 Race Red GT/CS: current
MGW race spec shifter, Borla ATAK axle backs w/ resonator deletes, Boss Intake Manifold w/ Steeda CAI, stainless power longtube headers, driveshaft shop carbon fiber drive shaft, ACT twin disc clutch.

2014 Race Red V6: sold
Airaid Cold Air Intake, pype bomb axle backs, bama 91p tune, ford racing 3.73 gears, Barton short throw shifter, Mac ceramic shorty headers.
MelloStang2010 is offline  
 
 
For the best viewing experience please update your browser to Google Chrome