Ford Mustang Forum - View Single Post - Steeda CMDP install, Screws Problem !
View Single Post
post #1 of (permalink) Old 05-12-2007 Thread Starter
Petit Poney
Apprentice
 
Petit Poney's Avatar
 
Joined: Apr 2007
Location: Monaco
Posts: 82
 
Steeda CMDP install, Screws Problem !

I just install the new (cheap) Steeda Charge Motion Delete Plates, all performed in one hour and half without major problem despite my limited skill in mecanic, plug in the Predator and install the tune, everything ok !
My heath runing 150 plulses, I switch on ignition and miracle, the engine start on the first atempt and iddle is regular !
Short run, perfect is the word !
Back to my garage, clean and put back everything, and Surprise, found the four Torx head screws on the shelf !!!!! (the one which keeps CMDP on the inlet air box)
I knew that maybe something had to be wrong, that's it !!
Question, can I drive the car like that or do I need to dismantle the inlet air box again and put these lovely screws ?
I was so happy !!!!!
Thanks for your help to a poor French lost on the other part of Atlantic !!!


Mustang 05 GT Sceaming Yellow, manual. Steeda CAI + Predator Bamachip tunes, CMDP, Underdrive Pulley,
Eibach Pro springs, Tokico D spec,Camber plates Steeda Adj Panhard bar + brace, Front G brace, Uca + Lca's & relocation brakets, oil separator, hood pins. FRPP GTA muffler, Saleen HID Headlights & short throw shifter. Steeda 18" Pentar wheels with 255/45/18 front, 275/40/18 back, sequential tail lights.
Petit Poney is offline  
 
 
For the best viewing experience please update your browser to Google Chrome