Ford Mustang Forum - View Single Post - BMR Tech's S550 Mustang Build: Street/Strip
View Single Post
post #16 of (permalink) Old 10-28-2014 Thread Starter
BMR Tech
Site Sponsor
 
BMR Tech's Avatar
 
Joined: Nov 2010
Location: Southeast
Posts: 711
 
Quote:
Originally Posted by 908ssp View Post
You need to someone who can make a mold for you so you can use the bottom half of the stock cold air intake instead of resorting to a hot air intake.
When JLT releases the High Boost kit, I will grab it.

There is a good bit of space in the fender/bumper well....so that will be where I run the filter eventually. I am very picky about IAT, etc etc etc. This is temporary, to get the car going.

I also trimmed the grille a little, to open up the feed to the air filter.

Between the E85, and the mods I am doing for fresh air - I think at speed it will work fine.


Dylan Abbott
[email protected]
813.986.9302

www.bmrsuspension.com

VISIT FOR PRODUCT ADVICE, TECH AND SUPPORT ON FACEBOOK. www.facebook.com/BMRMustangSupport
BMR Tech is offline  
 
 
For the best viewing experience please update your browser to Google Chrome