Ford Mustang Forum banner

1969 mustang

  1. Suspension: Is spending more worth it? What parts can you not cheap out on?

    Classic Tech
    Hey guys, I've been saving up to replace most of my suspension. New Upper and Lower control arms, tie rods, etc. Bigger front sway bar, rear sway bar, shocks, and springs. I was originally planning on getting this kit that includes Grab-a-trak, addco, and KYB parts in the mustangs unlimited...
  2. Getting Sponsored: Is it Worth it to Try?

    Classic Talk
    Hey guys, So like everyone else, I want to continue to build my car, but don't always have the money. I could use some help. I've heard of some people getting sponsored and receiving free parts, or getting huge discounts. I looked into it and found a website called CarSponsors.com. You can pay...
  3. 1969 Mustang Front Chin Spoiler

    Classic Tech
    I was wondering anyone has installed a front spoiler onto their 69. I think it adds a great and aggressive look, and it's a pretty cheap part so I thought why not. Is it a fairly easy installation? will I run into any problems?
  4. !969 Mustang Front Chin Spoiler

    Classic Tech
    I was wondering anyone has installed a front spoiler onto their 69. I think it adds a great and aggressive look, and it's a pretty cheap part so I thought why not. Is it a fairly easy installation? will I run into any problems?
  5. 1969 Mustang Aftermarket Exhaust System..

    Classic Talk
    Finalizing my exhaust order.. check this list out.. Headers: Doug's - Ceramic Coated, Tri-Y Headers, 1/58" into 2", collector diameter 2.5" Pipes: Pypes - performance exhaust system, Stainless Steel, Natural, X-Pipe, Header-Back, Race-Pro, w/o mufflers 2.5" Mufflers: Borla - "S-Type"...
  6. 1969 Mustang 302 Engine Performance Questions..

    Classic Tech
    What to do.. what to do.. Besides an aluminum intake & 600 Holley/& Exhaust What can I do internally to this 302 for solid performance, daily driver, looking for nice response, not too expensive.. was told the C4 trans has a "shift kit".. I have not even driven the car yet, due to storing it...
  7. 1969 Mustang Brake Swap Help

    Classic Tech
    I was thinking earlier what I want to do to my 69 fastback I am wondering whether I can run a 4th Gen. front disc brake setup on my 69 Mustang without any major problems, it so I was wondering if you could tell me what all I'll need off of the donor car to complete the build. Also , I'm...
  8. swaping engine out of a 1969 mustang convertible,,

    V6 Tech
    Need little help,,just a point in the right direction,There was a 6 cylinder in it but when i got it it was just a shell. im planning on puting a 351w in it,i changed the engine mount. but im not sure what else to replace.do i have to change the bar right below it,and if so what is it called? i...
  9. C4 Tranny help needed with slippage

    Classic Tech
    Hey all thanks for looking at this. I have a 1969 c4 tranny in my 1966 pony. When it shifts from 2nd to 3rd gear if I am accelerating slowly it will slip into the 3rd gear (my engine will rev a little high until it gets into gear). If I am accelerating at a nice moderate speed it will go into...
  10. 1969 Mustang accelerator cable popping off the pedal rod

    Classic Tech
    Maybe it's just a design thing, but the pedal end of my 1969 convertible's accelerator cable keeps "popping off" the pedal lever bar. I guess I will add a small piece of twisted wire to the end of the rod just to hold the cable in place, since I cannot think of any reason not to. Anyone else see...
  11. 1969 Mustang starter stays engaged

    Classic Tech
    I have a 1969 mustang 302 with C4 automatic, when I start it the starter turns the engine over fine and if the the engine does not start the starter will cut off immediately so i know the switch is not sticking but if the engine starts then the starter stays engaged, and will not disengage, I've...
  12. 1969 Mustang Engine Problems

    Classic Tech
    Looking for some advice. I recently was driving my car when I looked down and noticed my engine temp was 250. I imediately pulled off to investigate, turned out my fan melted my inline fuse holder in half. So, I cut and stripped the wires to return my fan into operation to get home and park...
  13. 1969 Mustang

    1969 Mustang

  14. 1969 Mustang

    1969 Mustang

Top