Search Results for ‘331 stroker’

I am new to this forum and new to most internal engine work thus beg the advice of more knowledgeable folk. My current plan is to take the stock 302 block I pulled from a 1990 Ford f-150 long bed and stroke it to be a 331. Convert to carbureted intake using a scott drake four barrel intake and...

Hello everyone. Just wanted to get some advice on a build i plan on starting next month and wanted some recommendations on if I am heading in the right direction with my build. Advice is very welcome as i have not torn down a motor in quite some time. I am looking to keep this 550+ streetable hp...

I have a 331 with aftermarket heads. I used the push rod lenth comp cams recommended and the rocker bottoms out on stud. Just wondering if what I am doing is wrong? I used a 1/2 inch longer pushrods than recommended and it seemed to fix the problem I quess. I've never had stud mount rockers...

Hey guys/gals! So I'm planning on running a 331 stroker with a kenne bell 2.1 blower. With a set of twisted wedge heads. I was wondering if anyone has run this setup or if any one has any suggestions, good or bad. Such as bore size, head gasket, ignition setup, or anything else I might need...

I have a 1990 Mustang gt that I have recently put a 331 stroker in. The engine came out of another car but had very few miles on it. I checked the compression and it was good. And got the timing set properly, but the car still has a pretty good miss in it.. ANY suggestions on what to do or check...

I just picked up a 1991 gt, the engine is out of the car and has a fresh rebuild, never had oil run through it but i want to build a serious engine, this is all stock. Im just starting to learn engines, i want a stroker setup and a supercharger. I was looking into the stroker/supercharger...

Hi guys, i recently picked up a 1992 gt which already has a Mac full exhaust, 75mm BBK throttle body, BBK Egr plate, Mac cold air intake, and aluminum driveline, aluminum underdrive pulley kit. A buddy of mine has a set of ported e7 heads that he is willing to give me for free. My question is...

Hey guys, i am in the process of taking the engine out of my 1991 mustang gt. I have already bought most of the parts to put on the engine, i have gt40p heads, trick flow upper and lower intake, and a 80mm throttle body. I am sending the bottom end out to get rebuilt, and i was planning on doing...

hey whats up guys and gals? my name is travis but in the forum/blog world i go by thtanoyinguy. well, today i bought a 1990 Mustang LX with a 302 stroked out to 331 with a lunatic cam with a 280 lift, 28 lbs injectors, 76mm throttle body, 80mm mass air and 4.10 gears...normally i dont buy cars...