Ford Mustang Forum banner
Cancel

Search Results for ‘4.6l dohc engine’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results

Search Tags

1965 1966 1967 1968 2.3 2005 2006 2007 2011 289 3.8 302 4.6 5.0 alternator american iron cmc mustang automatic battery brakes bullitt cai cam cj pony parts classic clutch cobra cold air intake conversion convertible coupe electrical engine engine swap exhaust flowmaster ford ford gt fox body foxbody fuel fuel pump gears gt500 headers headlights heads hood horsepower idle ignition install intake interior introduction leak lights mach 1 manual misfire mods muffler mustang mustang car show mustang gt noise oil paint parts performance power problem problems radio rear end rebuild rims roush s197 sale sct shelby sn95 springs starter steeda supercharger suspension swap throttle body timing tires transmission tune tuner turbo v6 mustang video videos wheels wiring
  1. 4.6L Tech
    hello so I have a 2003 Ford mustang Mach 1. so when I take the car out for a drive on start up u you know white smoke will come out because of condensation. when it’s warm and I’m driving the car I see no white smoke. but when I turn off the car and wait a little bit start it back up there will...
    4.6l dohc engine mach1 white smoke
  2. SVT Cobra Tech
    I have most likely "spun a bearing" in my 147,XXX miles 1997 Cobra. I noticed oil pressure problems and grinding noises earlier this year and was heavily advised not to crank it to keep from making things worse. I took it to a shop, and they were going to charge me way too much to pull the oil...
    4.6l dohc engine bearing crankshaft motor swap short block
  3. SVT Cobra Tech
    I just picked up a 1997 cobra that had a miss. I got the car for next to nothing so I wasnt to worried about it. It is either cylinder 5 or 1 but I ran a compression test and it only has about 10-15psi of pressure. Any ideas of what could cause this? Ive heard a couple things about a valve being...
    4.6l dohc engine cylinder dead dead cylinder motor
  4. 4.6L Talk
    Is it true that the engine has to be removed to change the head gasket on a 4.6l DOHC Engine. Also does anyone know about how much a whole new engine runs? same size 4.6L DOHC. Would that be a better route to take. All feed back greatly appreciated it!
    4.6l dohc engine
1-4 of 4 Results
Top