Ford Mustang Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. 5.0L Tech
    OK I installed a 1991 5.0 HO engine into my 1967 mustang which was originally a 6cyl. we swapped out the timing gear cover and put on a clock wise water pump for a V belt for a 1970 mustang. I'm using a cast iron four barrel ford intake from an early model car. I have not replaced my radiator...
  2. 5.0L Tech
    I have an 89 5.0 HO Engine Code E. I am getting no spark out of the ignition coil. So far the igniotion coil, entire distributor assembly and ignition switch have been replaced. The coil has good voltage at the primaries and Ohm checks good across the primaries and secondary. As far as I can...
  3. 5.0L Tech
    Just wondering what inexpensive power adder modifications can be added to a 1988 mustang with 5.0 ho stock motor. I have an upgraded aod with 2300-2500 stall convertor and want the motor to match with around 500 hp.
  4. Classic Tech
    The oil pan that came on the 1969 mach I had the dipstick tube hole in the from sump area pluged. the tube in the block goes into the back of the pan were it hits the shallow area but does not touch the oil to give me a proper level reading. This pan is is also one full inch or more "shollower"...
  5. 5.0L Tech
    Okay, so i found an '85 5.0 HO for sale. I want to rebuild it and put it in my 93 hatchback. Are these year engines any good? I think the compression on these is different than the '86 to '93 engines. Plus they come carbed and i want fuel injection. I was lookin for parts from Late Model...
1-5 of 5 Results