Search Results for ‘air’

Hello all, I purchased a '90 Fox about a month ago, the A/C does not blow cold. The clutch will spin for a few seconds and stop. I'm not entirely sure where to go from there, and i believe the car has r-12 refrigerant. If anyone can shed light on my predicament it'd be greatly appreciated!

I just got a P171 fault code which is the Lean Bank 1which means im getting to much air and not enough fuel. I have a Spectra Air Intake with the large cleaner on it, if i change to smaller filter would this correct the to much air for bank one?

Hey guys I was just wondering if there really is a 'difference' between brands of cold air intakes. Steeda claims to have the highest performance boost between all the intakes I saw, but JLT is the cheapest and people say it is identical. Any input would be great.

Changed my cabin air filter (finally) after 35k miles. Thought i'd share a picture as i thought it was comical how dirty it was.

I have a 2000 mustang V6 with automatic. I am not able to get the electric air/smog pump to run at startup when the engine is cold. Also my check engine light is on and the code is P0412. First of all I have replaced the air/smog pump, CCRM, and relay attached to the air pump and I have checked...

Possible to add AC to a non AC 87lx? Too much work?

I have a 1997 GT. Both my high and low port o-rings are gone so the A/C system will leak out Freon in the matter of hours. I was going to replace the lines, BUT some folks say that you can just replace the ports and Ford carries the ports so they must be replaceable. So my real question it...

My car is a 2005 GT with 45k miles. Turned on my A/C cruising at 50 MPH while in a bend and the car stalled out! The AC had felt warm the previous use. Started back up with AC OFF, but now there is a grinding noise in AC Compressor area. OK, What did I break? and how much is this gonna cost...

Hi every!! ( New in the forum and bad inglish :?: ) recently entered his water car engine, i repair this and now have check engine light and have the next code my obd scanner show me this information: P0411 - Ford Type-> Powertrain - Auxiliary Emission Controls - ISO/SAE Controlled...

Has anybody ever tried to fit the 2010 factory cold air intake onto an 05-09 GT? I don't know if it would fit. I like the factory look but I want the 15 or so horsepower upgrade.

2001 v6 3.8L Basic - 65,000 miles - Recently Bought, was an insurance salvage Bought car with 2 codes - P0125 - Insufficient Coolant Temperature for Closed Loop Fuel Control P0453 - Evaporative Emission Control System Pressure Sensor High Input I think i fixed po125. checked thermostat and...

Hi There, After a lot of troubleshooting on my car, I have noticed that the A/C Compressor is ceased. I tried to turn the cog and its totally stuck. Starting the car just moves the tensioner and it wont budge. It started when I was driving along and the A/C stopped blowing cold air. Then I...

Okay, so i just installed a new cold air intake on my 03 v6 and everything seems like its working fine except my check engine light is on. does it need like a new tune or something because of the new amount of cold air going to the engine? the car isn't making any weird noises or anything like...

I have posted before on this problem but need to give everyone a heads up and what to be aware of. I purchased my 2011 Mustang new in June of 2010. Immediately I noticed that once in a while the air conditioner would blow warm air. It would last only a few seconds and then go back to cold where...

OBD2 code P0340 Camshaft position sensor A - Bank 1 circuit malfunction Where is the camshaft position sensor? And can someone post a picture do there 1994-1998 v6 air intake manifold vacuumed tubes I might have misplaced them in the wrong holes Thanks

I've been thinking about putting an air raid cool air intake on my 5.0 2011, because it doesn't need a tune. Would it be worth it?

I have a 02 GT that is giving me some problems. I got home from work and parked it and it was running fine. I didnt drive it all weekend and got in it monday to go to work and it was running ROUGH! I went back home and lifted the hood and the vacuum line going from the intake to the valve covers...

I've got 2 problems going on that may or may not be related. First problem is that the car doesn't want to start. It'll fire right up then spit and sputter and sometimes die back out. But usually you can pump the gas and get it to level out after a few seconds. I've run a can of Seafoam...

I have a "ball louver" for the passenger AC vent in my 69 (factory air) that I am refurbishing. the "ball louver" floats loosely in the housing. This is because the black felt (normally attached to the inside of the housing) that normally provides a friction fit to hold the louver in place, is...