Search Results for ‘balancer’

Hello everyone. I have had this ongoing noise in my car ever since they day I got it. Its about time I finally get around to fixing it. To me, it sounds like a spray paint can rattle coming from the front of the motor. I've already replaced the idler pulley and the tensioner pulley just because...

Ok, I had a shop tell me that this is minimal wobble and it's ok. Can someone take a look at this video and tell me if it's really ok? The wobble seems much more pronounced in real life than is visible on the video. It's the harmonic balancer / pulley deep in the engine, sorry for how...

The balancer on my 1998 mustang's DS has had the rubber rotted away and was just wandering around the drive shaft so i took it off my car. So now i need to replace this piece but I'm not sure how to go about doing so. Can i replace just the balancer? or do i need to replace a whole section or...

Little background: 1994 5.0 H/O from a GT in a 1966 Coupe. Long story short is we went to swap the harmonic balancer and the first couple threads were damaged and ended up completely destroying about a 1/2" of the threads in the crank itself. I ordered a replacement bolt from ARP and the plan...

hey guys, 1966 coupe with a 289 v8... im getting the engine back from the machine shop tomorrow and had a quick question.. once i get the cam and crank in, install the timing gears so that their marks are lined up and then put the timing cover on, is there a certain position the crank should...

Hey there, can't quite establish whether or not I have a problem or this is normal, therefore looking for help/advice. First the setup then the problem below: Stock 93 302 Engine Block F303 Cam Ported GT40 Heads (not p heads) MSD Ignition Double Roller Timing Cam Roller 1.7 rockers new...

Hey all, I got the center bolt out but I cant seem to get my balancer removal tool to fit on this balancer. there are only 2 holes that dont appear to be threaded?? Do I need a special tool to remove this balancer?? Thx Eric

so i have had problems with the spout to adjust the timing on my 5.0. when i plug it in, it idles roughly and wont stay alive, but it runs fine with it out. after doing some reading and some deeper looking under my hood, i realized that my harmonic balancer is way out of wack, it spinning all...