Ford Mustang Forum banner

bogging

  1. 2005-2010 Mustang GT Tech
    2006 Ford Mustang GT U7140 I have finally decided after a long time of struggle with my car to come to the place where my answer may lay. I have been struggling with engine trouble codes thrown: P0148= fuel delivery error P0171/P0174= system too lean bank 1/2 P1000= OBD System Readiness not...
  2. Classic Talk
    Hi I have a 1966 mustang and it starts and idles fine but when I let the clutch out and try to move it sputters and bogs even when warmed up so I have to give it lots of throttle. I have read manny fourms and threads and can figure this out it seems like a fuel probably. But when I am cruising...
  3. 5.0L Tech
    I just purchased my my 1990 GT Mustang not too long ago and it was running fine. Just recently it started bogging out in idle. I have already checked the throttle position sensor. The voltages were all in good ranges, except for the black wire (the signal return, ground wire was only 0.3 ohms...
  4. 5.0L Tech
    I just purchased my my 1990 GT Mustang not too long ago and it was running fine. Just recently it started bogging out in idle. I have already checked the throttle position sensor. The voltages were all in good ranges, except for the black wire (the signal return, ground wire was only 0.3 ohms...
  5. 5.0L Talk
    My car has been running strong. It still does. In the mornings it would sort-of bog after I had driven a mile or so for a little while. Then it would run great later in the day. I was trying to figure out what would cause this. I thought of "intake icing" I knew I had a leak in the radiator and...
  6. 2.3L Tech
    Alright, before parking my 1990 mustang for the summer I started noticing a problem on "hot" starts. I put quotations because i have let it sit an hour or two and it still does it sometimes. Basicly I will start the engine and let it do It's thing to warm up. Within about 30 seconds the engine...
  7. Classic Tech
    ok, I have a 1968 Rebuilt 289ci with 302 heads, an edelbrock performer 289 intake with an edelbrock 600cfm 4brl carb, stock dizzy with new insides (still points). I changed my plugs which were really fouled, set my spark wires accord to chilton (two were in the wrong order). Im sitting at 15in...
  8. 4.6L Tech
    My 2002 Mustang GT had been running fine without any problems. It began raining the other day and of course I enjoy playing some while it is wet and most times I leave the traction control on. This allows the rear wheels to spin in a mild manner but can still be controlable in traffic. The other...
  9. 4.6L Tech
    I have a 2002 Mustang GT 5 speed. Yesterday when I was driving at about 55 mph I put it into neutral just to coast. My car just surged down in rpms and stalled. It started right back up with no problem in the turning lane. Today, I took it to test it out and see how it was running. It never...
  10. 5.0L Tech
    I have an 87 mustang gt, has bbk shortys and h pipe, 3.73s, converted to mass air. It idles fine and will run smooth if I baby it but if I try to open it up any then it will bog down real bad, my mass air conversion was just fine for about a month, so I don't think that would be it, I checked...
  11. V6 Tech
    First I did try to research this and did a couple of the simpler checks. I recently had to replace the fuel pump on my mustang and it was working fine. Although it is spring here in Memphis, it got really cold one day and this is when it started to bog down and make popping noises if I tried to...
  12. 2005-2010 Mustang GT Tech
    Last year I installed a Kenne Bell supercharger in my 2006 GT. There were a few hiccups along the way, but overall it seemed to go pretty well. However, the first morning I drove the car, I nearly got into an accident when I pulled out into traffic and the engine bogged and sputtered, then...
  13. 4.6L Tech
    I have a 1996 Gt 5-speed. It has ran great since i bought it. Up to a couple of weeks ago it started bogging down while running. Idles really hard sounds like i have huge cams then dies. It turns over and over with no luck.(just ocational start ups with it camming real hard then it dies again) I...
  14. 5.0L Tech
    Working on my little brother's car, he bought a project. It's a 1988 shell with a '91 computer and all mass air equipement(5-0). Bought the car like this and it has been tough just getting it to run. At first we had all kinds of vacuum leaks and an intake gasket leak, took care of all that. Now...
  15. 2.3L Tech
    :waveyNew too this stuff but need help! I got a 89 mustang convertable with a 2.3L 4 plug non-turbo automatic. The car ran great when I got it but then about 4 months of driving it two of the volves burnt on the head so I had the head redone and got it all back together with new plugs, cap...
  16. 5.0L Tech
    Hi, I have a 1990 LX notch that dies on me when I let the clutch out (doesn't actually stall), but as soon as you put clutch back in it revs right back up. The idle isn't that smooth either. any ideas on what might be the problem would be great.
  17. 2005-2010 Mustang GT Tech
    I have been looking through the forums and have yet to find and answer to my issue. I recently installed a CAI, delete plates, UDP, high flow CATs and x-pipe and axle back exhaust. All parts are from Steeda. I tunned the car with an SCT SF3 with the canned tunes that it shipped with from Steeda...
Top