Ford Mustang Forum banner


  1. Master cylinder pressure

    Classic Tech
    Hi everyone, 66 Mustang coupe, 289/auto, factory disc brakes up front, rear drums. So I've had the car fully up on jack stands for 3 or 4 months doing some work to the rear and suspension, but haven't touched the braking system at all. Finally got finished everything I was working on, lowered...
  2. jerking when braking

    5.0L Tech
    I need ya help. I have a 92 foxbody and I warm it up for a few mins every morning but every once in a while after i turn it on and leave running, I drive and when I brake it starts to shake and acts like it will shut off. It goes away after its completely warmed up. Then drives like a champ...
  3. Ford Mustang vs other brands

    2011 - 2014 V6 Mustang Tech
    What's up everyone, interested in buying a mustang. I currently drive a bmw 325i 2006. I test drove a 2012 V6 Premium with 28,000 miles on it, I noticed when braking that my bmw breaks so much better and I changed those brakes around 23,000 miles ago so both have similar wear on them. I just...
  4. Need more Braking power. Will rotor and pad upgrade only help?

    2005-2010 Mustang GT Tech
    So I was wondering if any of you notice at high speeds (70 obo.) your stang 1) seems to lack a bit of braking power 2) feels like the rotors are slightly grinding under braking. I was thinking about upgrading my fronts, but not spending a whole lot by a complete conversion (rotors, pads...
  5. Upper control arm/front suspension question..

    Classic Tech
    289, t5, 14 inch cregars, SSBC front disk brakes, 600 CFM edlebrock carb... I have a question for all you enthusiasts out there that know what the hell they are doing, unlike myself. So, I was reading an article on lowering the control arm one inch for better corning and less body roll. Here...
  6. Clicking Noise While Turning and Braking on 1993 Mustang LX

    5.0L Tech
    Took our '93 LX convertible 5.0 up the Blueridge Parkway last weekend, and started hearing a click or snap when turning left and braking. Not when just braking or just turning, only when turning left AND braking at the same time. 63k miles, all original. Any ideas? Planning on pulling the...
  7. 2000 Mustang V6 Radio screen and odometer turns out when braking

    V6 Tech
    I have a Mustang 2000 V6 and the radio screen and the digital odometer goes out when braking. Iv upgraded the rear lights (braking) for leds. They work perfectly exept for this issue. Its anoying. Do someone else had this problem and know how to fix it?
  8. 1994 V6 Mustang front end shaking

    V6 Tech
    I have a 1994 Mustang 3.8 V6 convertable with approx. 159k miles and under moderate braking the frontend of the car shakes violently that can be felt through the steering wheel, its not as bad under light or hard braking, I have already repalced both lower ball joints, short of just redoing the...
  9. Knocking noise when braking.

    V6 Tech
    Whenever I brake moderately hard my car makes a knocking noise that seems to come from where the brake pedal is. It doesn't do it if I brake softly. My dad says it's because the tires are worn out and the anti-lock is engaging. I have a 2002 v6 Mustang. Any one know what it could be?
  10. rough idling almost stalling 1987 5.0 mustang

    5.0L Tech
    i thought it was my bad alternator at first, i replaced the alternator battery and starter, i changed the plugs wires the cap and rotor are fine and it doesnt stall anymore but when coming to a stop the car kicks and the idle revs between 500 and 1200 and when cold running it slips outta drive...
  11. 1996 Mustang v6 3.8L Stoplight Switch HELP?

    V6 Tech
    Im having a problem with my 1996 Ford Mustang v6, 3.8L, normal mustang. Today while driving, somebody told me my brake lights arent working. I went home, and checked. Point is, parking lights work where the brake lights shine. The problem is the (braking) Stop light switch, correct? IF so, I...