Ford Mustang Forum banner

built

  1. Stock 2008 Malibu keeping up with my 95 5.0?!!

    5.0L Talk
    My buddy just got his 2005 chevy malibu and I just got my 95 Mustang GT with Gt 40 headers, aftermarket Intake with throttle body and bbk shorty headers. Also has 4:10 posi gears. AND a High lift thumper cam and he kept up??! I slowley started to leave him but how did I not dust him? Is there...
  2. 2008 mustang improvements

    2005-2010 Mustang GT Tech
    I've been putting work into my 2008 mustang and trying to figure out what to add next. Any suggestions?! Preferably something that doesn't break the bank! There is a picture of the car. (Could only figure out how to load one at a time). Things I've done so far: New stereo Interior LED system...
  3. Need options/opinions on forged internals

    2005-2010 Mustang GT Tech
    I am looking to get my block built up to handle the 550HP ford racing kit. I am wanting to start with the internals. So I am wondering what rotating assembly would be the best for this kit. Thanks in advance!
  4. 4.6 motor build bolt question

    4.6L Tech
    I currently have a built bottom end H-Beam manley rods and CP pistons all forged.. My question is where can I find some main cap bolts? It's all assembled but Im not sure if the shop who assembled it used the factory torque to yield bolts or not that i had dropped the block off with so I dont...
  5. I Need Ideas! HP Junkies Needed!

    5.0L Talk
    Heres the deal, I have a 5.0 with 300hp at the rear wheels, I want to push 360 or so, I need ideas on what to do. Id rather not get into the internal engine components but opinions are still considered. Engine Now: 302, with F303 cam, edelbrock aluminum heads, edelbrock performer intake, 24lb...
  6. Vacuum Leak!? Need Help Please!

    5.0L Tech
    I have been dealing with a vacuum leak for ages and finally just noticed something, im not sure if this needs to be hooked up or not but I have a feeling it does but I dont know what it is or where the line would go! It is behind the intake to the right of the egr. Thanks in advance
  7. What are these?

    5.0L Tech
    #1 Passenger side, missing some wires #2 Driver side, front of engine, above oil filter #3 Missing bolt on intake, could this cause a vacuum leak?
  8. Motor rebuild ,2000 Roush Stage II Mustang

    4.6L Tech
    i have a 2000 stage 2 roush, i am currently rebuilding my motor. i have bored it 20 over and bought je pistons and eagle connecting rods/crank. i an about to put the motor back in the car within the next week, is my car going to need to be tuned, or can i just put the motor in it and drive it?????
  9. New Built Motor!!!

    4.6L Tech
    Hey everyone, I just bought a new Camaro SS and so that leaves me with my mustang to upgrade to balls to the walls... i want to replace the stock v2 motor with a built v2 motor... i most likly will run 14psi supercharger and have NOS for those last min. burst of power... i was actually thinking...
Top