Ford Mustang Forum banner

clip

  1. 1965 Mustang Brake Line Replacement

    Classic Tech
    I have a 1965 mustang and i am replacing the brake line that runs from the engine bay to the rear. There are clips on the brake line underneath the car and there is no bolt to take them off and I don't know how to get them. Please help thank you
  2. 2012 Small Yellow Clip on Brake Aspirator Line

    2011-2014 Mustang Talk
    I have a new 2012 Kona Blue GT that I use as my DD. While installing my Airaid CAI, I had trouble getting the little yellow clip to pop up on the brake aspirator line (the line only auto transmissions have). When I finally got it to pop up so I could remove the line, the clip broke. The line...
  3. FMX 1969 Filter spring clip problem

    Classic Tech
    Hello, first post here. It sounds simple maybe but not so obvious to me about the oil fliter placement. I have a FMX C9Z and when I took of the oil pan the filter came with and dropped in the pan. After cleaning the filter trying to put it back but something is strange about the clip at the end...
  4. 1995 actuator lock rod clip is broken

    V6 Tech
    my passenger side door wont open with the key, power locks and handle work fine though, the key just turns and doesnt unlock the door i removed the interior panel to find a rod loose and a retainer clip broken. nothing was connected to the key lock. i replaced the retainer clip just yesterday...
  5. 88 5.0 o2 sensor connector delema

    5.0L Tech
    Hi, After jacking up my car to replace the tie rods, I noticed the harness that connects the o2 sensors to the harness had been dangling and the connector on the harness side had been damaged beyond repair. I went to the Junkyard and pulled the connector from the only 5.0 mustang they had...
  6. Floor mat clip / holder

    2005-2010 Mustang Talk
    Wondering if anyone has pictures or a simple fix for my floor mat holder. I have a 2006 GT and the plastic holder for the mat is loose and I am trying to fix without pulling back the carpet. I may just epoxy to the floorboard, but I would assume there is an easier fix. It doesn't appear that any...
  7. 1968 Mustang-Replacing entire rear clip

    Classic Tech
    Hey guys, I have a 68 coupe and after finding both rear panels and the tailight panel to be 60% bondo I went ahead and just bought some restoration panels. Basically, in what order/how would you install these three? I bow down to your limitless knowledge....:worship
Top