Ford Mustang Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. 2005-2010 Mustang GT Tech
    Alright I have been chasing the cause of this noise since I got the car 5 years ago. The noise started showing up when I would be turning right with the car in 3rd gear at about 1800rpm. If I were to push the clutch in, the noise would go away. If I revved the engine to ~1800 rpm in neutral...
  2. 2015-2023 3.7L (V6) Mustang Tech
    Hi All, Am new here, please forgive any forum rule violations and feel free to correct. I own a 2016 Mustang, V6 3.7l - Automatic. My journey with the machine started with lot of excitements. It was amazing until i encountered the Clunk noise from the rear end of the car Issue: A clunk noise...
  3. 4.6L Tech
    Hello everyone, A couple months ago I swapped out the springs, struts/shocks, caster/camber plates, steeda tie rods and sway bars. I installed in place the eibach springs and sway bar, steeda tie rod adjustment ends, and koni adjustables. So when I turn my steering wheel a 1.5 turns to the right...
  4. 2011-2014 V6 Mustang Tech
    Just wanted to share my troubleshooting journey with everyone. I finally found a major cause of my drivetrain clunk and managed to reduce it to a barely perceivable level. TL;DR at the bottom. A little bit of history: the clunk started to manifest less than 6 months after the car was driven...
  5. Classic Tech
    This is my first time posting, and also my first time really learning about timing. My problem is that I am getting no spark at the plugs, I grounded cylinder No. 1 plug, and cylinder No. 2 to multiple different grounds while cranking the motor and I'm getting no spark from either. I'll...
  6. 5.0L Tech
    I have a 1995 mustang gt 5 speed with what seems to be either clutch or rear end knocking. I can't pin point where it's coming from. Maybe someone had this problem before? I just had my clutch replaced. I used an autozone replacement clutch nothing fancy since I just needed it running for now...
  7. Classic Tech
    Hi all, I have a 1965 mustang that had a worn 6 cyl 200 cid engine in it. Over the winter I had another engine rebuilt by our local engine shop. The rebuilt engine has numbers showing it is a 1966 6 cyl 200. So, Ive been doing the engine swap over the last 2 weeks with a friend of mine...
  8. 4.6L Tech
    Hi! First off, I am new here and I recently got my first car; a 2003 Ford Mustang GT. Before buying it I took it to a Ford dealership to have them inspect the car to see if there was anything wrong with it, they were surprised by how good the condition on the car were. Anyways, not even a week...
  9. 2005-2010 Mustang GT Tech
    I have 36k miles on my car. Before I lowered it, there was clunk in the front end whenever I was driving slow down a road that has small bumps or uneven concrete seams. This happened primarily on the the passenger side when no passenger was in the car. Now that I am lowered the sound is more...
  10. 2.3L Tech
    Alright so my car keeps killing me with problems. I love her but geez. Anyways newest problem. My clutch was slipping a little, so I did the "self-adjustment lift the pedal up with your toe" technique. Now here's the problem. It adjusted itself to the floor at first, but with a nasty click about...
1-10 of 10 Results
Top