Ford Mustang Forum banner
clutch
1-20 of 279 Results
Advanced
  1. 4.6L Tech
    Just bought myself an 02 manual. Mechanically in great shape and the previous owner says the clutch is relatively new. When it is idling I hear a slight squeak that goes away when I engage the clutch even the slightest bit. Any help is much appreciated thank you.
  2. 2005-2010 Mustang GT Tech
    I was driving my car home from work and my clutch pedal sank to the floor and I couldn’t put it into any gear. I took it to a Ford dealership and they installed a McLeod clutch in it. I got the car back and the grab point was at the bottom of the pedal and then two days later I couldn’t get it...
  3. 2011 - 2014 V6 Mustang Tech
    I'll be taking Pony in to the mechanic tomorrow. It has suddenly began shuddering and then vibrating on the 5-6 shift and at speed when not shifting at all but simply decelerating from 2K rpm. The 5-6 shift shudder has never been present, neither has any 2K vibe and shudder; it's always only...
  4. 2011 - 2014 V6 Mustang Tech
    Hey guys, I have a 2012 V6 manual with 96k miles. I've been having a squeak and groaning sound simultaneously as I release the clutch from a stop and am slightly on the throttle. It tends to happen more if I don't match the input exactly perfect (potentially under rev?). It also makes the same...
  5. 2005-2010 V6 Mustang Tech
    Hello, Was hard to get into first gear so had Mike's Transmission in McKinney Texas install a new clutch kit for my 2005 V6 Ford Mustang. He said that he used the MOOG kit. Ever since the kit was installed there is a Rattle or Vibration Noise coming from the transmission while the car is...
  6. Classic Tech
    I just got a 66 mustang with the I6 and the 3 speed about a year ago that I daily drive and learning to drive manual on it has done a number to my clutch. My auto tech teacher said that my clutch is going to need to be replaced soon. Do you have any recommendation for a new clutch or anything I...
  7. Classic Tech
    Hello, Need some help.. I replaced the clutch in my 65 coupe, 289, 4 speed toploader. The car sat for several years, refurbishing the car. Replaced the clutch, pressure plate, flywheel was trued and, throw out bearing, and bushing in rear of engine. Adjust to specs from ford manual, press...
  8. V6 Talk
    Had transmission serviced again at over 200,000, has always been maintained. Ford said not to do this again at this mileage, that it would cause more damage than good. Trans has worked fine, until a few weeks later - trans seemed to not shift, as I stepped on gas the tach would seem to rise in...
  9. 4.6L Tech
    I’m thinking of replacing the entire clutch assembly on my 02 GT, one of the last owners put SLP long tube headers on it. I know for BBK, at least the passenger side header has to be dropped, but man I can’t find jack sh*t info on SLP headers. In y’all’s experience, how was a clutch/flywheel...
  10. Classic Tech
    I have a ‘65 289 C code convertible with a 3 speed manual transmission. I am changing out the clutch pedal because the hole for the clutch rod is badly worn and elongated. I also have clutch chatter. I’ve had a new clutch put in and that helped quite a bit—took out about 90% of the chatter...
  11. 2011 - 2014 Mustang GT Tech
    Recently my 2011 Mustang GT clutch went out, and I am in the process of replacing it. I am planning to put in an Exedy Stage 3 Clutch, Exedy T.O Bearing/ Slave Cylinder, and a steel braided clutch line. I have all of the parts, however when I opened up my clutch, there was only one dowel pin in...
  12. 2011-2014 Mustang Talk
    BLUF: Can I get stock part numbers for a pressure plate, bolts, disc, pilot bearing for a stock '12 GT and/or Boss from someone here? Long version: I have a '12 GT that I'd like to have a clutch ready to install when my current begins to fail, but the options are staggering. The difference...
  13. 2011 - 2014 Mustang GT Tech
    One question in particular: Is this something that can be done at home? My service manual states that I need Vehicle Communications Module and Integrated Diagnostic System software for the install. BUT...my service manual is not official Ford documentation, just an E-bay copy of it. I...
  14. Classic Tech
    I rebuilt the pedal support and I am now re-assembling everything back. I cannot put the big clutch assist spring in. This is the one inside the dash. I pulled out the clutch pedal on the shaft to go around the stop. Now it touches the firewall and there is still not enough travel to pull the...
  15. 2015+ 5.0 Mustang Talk
    Inspired by the guy who lost to the Jag while shifting into second - Every driving or racing video I watch, someone always comments on driver not knowing "how to shift, bro!" - and then they go on to say that if you practice enough then you can get perfectly smooth shifts in exactly 2...
  16. 4.6L Tech
    Hey all, So I tackled a flywheel/clutch/rear main seal job myself this past week (it took the whole week...) I put it all back together yesterday and got some pretty disturbing vibrations. I've been researching a lot and I've got a few ideas to get me going, but I was hoping to get anyone's...
  17. Classic Tech
    Hi, My Mustang convertible from 1965 has got the standard interior door panels with standard armrests and a manual 4 speed gearbox. I'm 6'4" (194 cm) so while using the clutch, my long bent left leg gets chafed by the armrest. My question is if it would make any difference if changing the door...
  18. 2005-2010 Mustang GT Tech
    Greetings! I've had my 07 Mustang Gt for a little over a year now. 116k miles, manual transmission, and its mostly stock. Since I got the car, there has been a chatter coming from the transmission but I've been told this is normal to an extent with this model. As the year went by, the chatter...
  19. Classic Tech
    Anyone know how to adjust a clutch that is New install... never adjusted previously. I've just engine swapped and have a new 302 4 speed in. The trouble I'm having is knowing how to get the freeplay in the clutch pedal. Clutch pedal is smooth and has strong return spring. It either stays at...
  20. V6 Tech
    Hello all, I just bought my Mustang about a month ago and after the euphoria wore off, I am now left realizing that I may have some serious driveline issues. There are a ton of different "symptoms" my Stang is exhibiting that has me a little worried. Any help on what may be the issue is highly...
1-20 of 279 Results
Top