Ford Mustang Forum banner

connector

  1. 2011 - 2014 V6 Mustang Tech
    So...I've neglected to check underneath that red rubber cover on the positive terminal on the battery since I've had the car (Oct. 2010). I finally needed to change the battery and this is what I found... That is what it looked like AFTER I cleaned it up. Before, it was completely covered...
  2. 5.0L Tech
    1991 Mustang GT: Been having a ground issue and already checked the basics. I jacked up the car and while checking this and that came across a small nest of wires and harnesses located south of the o2 sensor on the drivers side; again undercarriage. There's a larger circular shaped...
  3. 5.0L Tech
    Hi, After jacking up my car to replace the tie rods, I noticed the harness that connects the o2 sensors to the harness had been dangling and the connector on the harness side had been damaged beyond repair. I went to the Junkyard and pulled the connector from the only 5.0 mustang they had...
  4. Classic Tech
    Hi, I have a problem that I need solved immediately if anybody can help. I have a 1970 mach 1 that is need of the under Dash wiring. My car has NO tach and DOES have A/C. CJ Pony Parts has one only WITH a tach. I know the connector that goes to the cluster can be modified to fit a NON tach car...
  5. V6 Tech
    I'm in the process of cleaning/fixing up my sister's 1994 Mustang convertible (V6, 3.8L), which I'm driving for a while. I was working on the interior and noticed an electical connector under the glove box that was just hanging, not connected to anything. I'm unable to locate an obvious...
  6. V6 Tech
    As I removed the electrical connector off the first fuel injector, the piece that was inside of the locking mechanism came off (see link to image below). I was very careful with the next 5, but in each case no matter how careful I was this piece (the locking pin) would fall out after I would...
Top