Ford Mustang Forum banner

coupe

  1. Classic Tech
    If I leave my battery connected to my mustang for more than a day or so, it dies. I replaced the voltage regulator (?) (think of the positive battery wire. It runs to this little cylinder, and then it goes to the starter) Anyway, I replaced that and it worked! Until about four days later. I...
  2. Classic Talk
    Hello, I have a 1967 Ford Mustang (Hardtop). It was bulid in Mexico and I live in Mexico too (Guadalajara). So the Serial number (VIN) is rally different to what I've seen in several guides for engine/model identification. The problem is basically I don't know which engine does it have, I was...
  3. 2005-2010 Mustang Talk
    I was looking at their site and there are several things i want to get: 1.V6 True Dual Exhaust Conversion Kit w/Valance 2010 2.DG Custom Auto 2010 Skull Cap Mirror Covers 3.3Dcarbon 2010 Headlight Splitters but I was doing research and i couldn't find any review or anything on their service...
  4. Classic Talk
    Hi all! I'm almost ready to put new upholstery in my mustang. I figured that i would add a bit of safety and install some aftermarket headrests on the front buckets. I've been looking around and all i have been able to find are headrests specifically for "64-67" mustangs. of course, given these...
  5. Classic Talk
    I'm pretty new to mustangs but I'm in the middle of restoring a 1967 Coupe and I need to know if this console would fit in my Mustang
  6. Audio, Video, Navigation & Alarms
    1998 mustang coupe okay, basically- as most of you may already know- the mach 460 system for a 1998 mustang coupe consists of 3 amps: one in the front that powers high and mid ranged sounds for the front and rear speakers, and two amps in the back (one on either side of the car) that power the...
  7. Classic Tech
    I was just taking the car down the road and i was going 20mph and the needle shot up to 90mph and then stopped working! does anyone think this is the cable that connects it to the transmission:headscratch: any help is very much appreciated, Kyle
  8. Classic Talk
    Hello, I have a 68 6 cyl mustang that does not have the factory steel wheels on it. I want to put them back on but I do not have them. Does anyone know of a good place to get them? I will also need the hubcaps too. Most of the sites I search come up with only aftermarket non OE production...
  9. Classic Tech
    hi I found a trunk release cable in mustangs unlimited but they only go up to 1970 on the classic years does anybody know if i can just install on of these years on my 1973 coupe or know where i can buy one made for my mustang
  10. V6 Talk
    I have been looking for a new grille with fog lights for my 2005 mustang v6 coupe. I have also been reading that a GT grille will not fit into a v6. So, do you guys think that this grille will work: V6 to GT Grille Kit; Price includes Shipping! Two sets of ShowLenses FREE with order! Click on...
  11. Classic Talk
    I would like to know if Ford ever produced a 1967 notchback/coupe/hardtop GT. I've seen GTAs (a GT with Automatic transmissions) and GT fastbacks but how about a coupe GT with manual transmission in '67. I know 3spd and 4spd were available. I believe the GT package was fog lights in the...
  12. 2005-2010 V6 Mustang Tech
    Okay, I'm researching tuners to add some power to my 2005 mustang v6 coupe. While I was looking I found a post on yahoo answers, which, by the way, I know is not always right. When asked if a DiabloSport Predator effects gas mileage someone responded: "Most chips are a cheap way of tricking...
  13. Classic Tech
    Hey, guys! Been a looooooong time, I know. Unfortunately, the Lady is not my only project. I have 4 children and Hubby and I have bought a house and moved and been in renovations of one form or another. Life keeps us busy, to say the least. As of late, Hubby and I have rekindled our efforts in...
  14. Classic Tech
    I have already posted here but I cannot figure out how to post on the regular forums. but here is my problem. I have a 65 mustang coupe with a 302 and I just installed a new clutch but the pedal is about 3 inches from the ground and I cannot shift barely at all. I think that the pedal is not...
  15. Classic Talk
    While driving down the road yesterday I found a 65 Coupe, straight 6, new paint, no rust, carpet is a little rough but no cracking on the leather, 2000miles on the engine since its been completely rebuilt, and only 101,701 original miles. The guy that's selling it is 76, and bought it off the...
  16. Classic Talk
    I have a 1965 mustang coupe with a 302 in it and I would like to know what are my possibilities for adding headers to it. The space looks pretty cramped.
  17. Classic Tech
    Hi, I have a 1970 Mustang 302 coupe, its been in storage all winter and has now come out, in March i put a new water pump in to stop it from squeeling last year, and now after driving it a little bit i decided to give it a rev, and my belts started squeeling again. I wonder if it was...
  18. Introductions
    Hi! Just a few days ago I traded my 2001 Z06 in on a 2007 Mustang GT. On the window sticker it says it's a 2007 GT Coupe Deluxe, V8, 4.6L. The car has Cobra emblems on each side and one in the back. I'm going to upload photos because I don't believe it's really a Cobra. I'm kinda dumb where...
  19. Classic Tech
    In my 68 coupe i have a brake light issue. Whenever my lights are on and i apply my brakes my left side tail light goes completely out but my right side works perfectly. However when i my lights are off everything works as it should. Any ideas?
  20. Introductions
    I would like to start off by saying HI! and out of all the mustang forums i liked all the feed back that people were getting for there questions here at AFM and my question for all you experts is what should i do for rebuilding my 289 n my 66 coupe with a C4 tran I plan to use this car for my...
Top