Ford Mustang Forum banner

diff

  1. 2005-2010 V6 Mustang Tech
    Hey there, looking for some advice on what parts I might consider replacing in my 2006 V6 while I have the rear end apart. I'm installing a limited slip diff and some 4.10 gears. I got the install kit with the bearings and gaskets. A guy I talked to about doing it mentioned something about...
  2. 2011 - 2014 Mustang GT Tech
    Hi all, I'm going to be installing some BMR LCA this weekend and I'm just wondering how you guys get the rear up? I see a lot of people stressing NOT to lift using the Diff. This is my first time lifting a vehicle and I'm just wondering what the proper way would be? Can I use a floor jack to...
  3. Classic Tech
    Hi all Can anyone help me please. I think I have too much play in my diff. - need to know if I need to renovate it or if this is normal. Please see these videos; The other rear wheel is on the ground and I am sure I'd have had it in 'Park' when I took it - Is this excessive .. The noise it...
  4. 5.0L Tech
    Can I beef up my existing rear end or do I need to replace max power around 390 -400 planned? Came out of a saleen so I think it has the traction lock....
  5. 5.0L Tech
    Okay soooo went to replace my pinion seal. I was going to put in some new 3.73s but It already had them. so I figured ok ill just do the seal. the diff fluid and the cover gasket. well it took me 5 secs to take off the shaft and remove the pinion bolt with my fingers. that easy. the fluid was...
  6. V6 Tech
    I am the proud new owner of a gently used Auburn differential and am in need of some advice. I am keeping my gear ratio the same so the pinion is staying in. Do I just pull the axles back, remove the carrier bearings and swap diffs or is there more to it? Are there any parts or special tools...
  7. V6 Tech
    Hi, I came across this differential and thought it was pretty cool: Auburn Gear ECTED - Ford Mustang I was just wondering if i could throw this in my rear end with new 8.8 in gears and axles? cause i was looking to beef up my 7.5 rear end to 3.73 gears. I know 8.8in won't give me any extra...
  8. V6 Tech
    Hi, I know that Im not very good with the mechanic ..but can anyone tell me what can I do to make the two rear wheel of my mustang turn because I have the v6 and there is only one that make burnout. So what the cheapest way to do this ? thanks for info!!
  9. 2005-2010 Mustang GT Tech
    I USE MY CAR FOR DRAG RACING AND DRIFTING So, it goes through alot of abuse. This is my secong time replacing the stock diff. I have the option to get 1. T-2 Torsen Diff M-4204-T31 2. AuburnPro Limited M-4204-P31 3. TRaction-lok limited slip diff M-4204-F318C I don't know which one to get, I...
Top