Ford Mustang Forum banner
Cancel

Search Results for ‘dowels’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

1965 1966 1967 1968 2.3 2005 2006 2007 2011 289 3.8 302 4.6 5.0 alternator american iron cmc mustang automatic battery brakes bullitt cai cam cj pony parts classic clutch cobra cold air intake conversion convertible coupe electrical engine engine swap exhaust flowmaster ford ford gt fox body foxbody fuel fuel pump gears gt500 headers headlights heads hood horsepower idle ignition install intake interior introduction leak lights mach 1 manual misfire mods muffler mustang mustang car show mustang gt noise oil paint parts performance power problem problems radio rear end rebuild rims roush s197 sale sct shelby sn95 springs starter steeda supercharger suspension swap throttle body timing tires transmission tune tuner turbo v6 mustang video videos wheels wiring
  1. 2011-2014 Mustang GT Tech
    Recently my 2011 Mustang GT clutch went out, and I am in the process of replacing it. I am planning to put in an Exedy Stage 3 Clutch, Exedy T.O Bearing/ Slave Cylinder, and a steel braided clutch line. I have all of the parts, however when I opened up my clutch, there was only one dowel pin in...
    clutch dowels help me
  2. 4.6L Tech
    I am in the middle of putting in a new clutch in the Stang. I ordered and drove all over town picking up the (3) dowels for the pressure plate to flywheel alignment. They gave me STEPPED dowels (Ford#6397) and the larger end that sticks out of the flywheel is too large to fit in the P. plate...
    4.6 clutch dowels flywheel pressure plate
1-2 of 2 Results
Top