Ford Mustang Forum banner

electric fan

  1. Classic Tech
    I recently installed an electric fan on my 302 '68 mustang. I placed the electric fan thermostat in the location where the temp sending unit goes. Now I'm not sure where to place the temp sending unit. Any recommendations on how to make the two play along?
  2. 5.0L Tech
    I have a 1989 GT mostly stock 5speed I've put an electric fan on the car because of over heating issues, the car was working great but in the last few months it's starting to stall out and die on my when I'm coming to a stop... (Only when the ac is on) when coming to a stop if I do not let the...
  3. 5.0L Tech
    Does anyone know of a junk yard electric radiator fan I can get from my local junk yard that will fit a foxbody radiator?
  4. 4.6L Tech
    Hi everyone - New to this board and having trouble with a 96 GT I just bought. I know that the CCRM is notorious for failing on these things - but if I am reading the diagrams correctly and testing it correctly....I believe it is good. So here is my logic - please tell me if I am wrong. There...
  5. Classic Tech
    I have a 1966 Mustang coupe with a 302, C4 automatic transmission, air conditioning, power steering, power brakes. I recently swapped over from a 65-amp externally regulated alternator to a 3G internally regulated 95-amp alternator from PA Performance. I have an aluminum radiator with a Derale...
  6. 5.0L Tech
    Hey folks, first post. I'm new here, having just bought a mint '88 LX notch last summer. The car is mostly stock, only modifications done to it are a custom cat-less H-pipe exhaust setup (bought with it), 130amp alternator (installed myself) and complete sound system upgrade (also done myself)...
  7. 5.0L Tech
    Hello everybody I am currently having issues with a conversion of a ford taurus electric fan into a 89 5.0 i have 130amp alt fyi. in short i have installed a non relay controller 17.99 version (in coolant) temp probe works great, however it pulls to much voltage causing surging . upgraded to the...
  8. 5.0L Tech
    Hey everyone I could use a little help here... I have an electric fan installed in my '90 5.0 but it wasn't wired correctly to begin with. I bought a relay kit for it and I'm not sure what the best location is for the thermostat sensor that came with the kit. There are 2 possible spots to...
  9. 5.0L Tech
    After the installation of underdrive pulleys, I noticed that my temperature gauge needle tends to rise while at idle. I assume this is due to my pulley fan and the reduced speed at which the water pump pulley spins at idle. Since I installed, at the same time, an Edelbrock Victor high flow...
  10. 5.0L Tech
    Hello everybody, so i just set up my electric fan from a ford taurus (two wire)into my 89 notch saleen. i set it up just like the post on this website with the thermostat control the 75 amp relay the diode across the fan switch etc. I was testing the car and ten minutes later the fan stops...
  11. 5.0L Tech
    i have a 93 GT and im looking for the cheapest route on getting an electric fan! any ideas?
  12. 5.0L Tech
    :winksI have the taurus fan with the flexalite 33054 installed.i just installed a 180* thermostat I was running stock.My temp gauge on stock cluster climbs to 2-2 1/2 hashes past the 130 mark.Is that good?I just want to make ure the thermostat is open at or around that point before the fan kicks...
  13. Classic Tech
    Hello, First off I would like to introduce myself. My name is Travis and I bought a 1966 mustang coupe with a 302 engine. I love the car, but the owner before me did some shoddy repairs and such. I have went through the whole car and done everything the right way, however I still have...
  14. 5.0L Tech
    so i see those MarkVIII fans on ebay and corral around 60 bucks and i want to run one for a few more ponies. do they keep as cool as the mechanical stock fan? maby better? so all you do remove old fan and shroud,wire it up,make some brackets and bam 10 horsepower right???? do i need to do...
  15. 5.0L Tech
    Hey guys, I have a 66 fastback with a 1990 5.0L H.O. in it. Looking to do some of the basic mods to it considering its stock besides the exhaust, K&N filter, and no smog, no a/c, no power steering. my question is would underdrive pulleys make much of a difference considering its only turning...
  16. 5.0L Talk
    What would be the cheapest way to get a electric fan in the mustang? Lincoln car? or newer mustang? I need some information. Wiring info would help.
Top