Ford Mustang Forum banner

engine compartment

  1. Engine bay project

    Classic Tech
    Hey folks. So I just pulled the engine and tranny from my '67 Coupe and I'm working on stripping the engine compartment. Before I get going on the project I thought I'd run my plan by some folks who have some experience and see if I have any flaws in the plan. I have two plans, so I'm curious...
  2. Use of rivets on new interior engine compartment panel 1967 Mustang coupe

    Classic Tech
    My right front passenger interior fender panel was totally rusted out from battery acid, so I cut the panel out, ground down the spot welds on the adjacent panels, bought a replacement panel and installed the new panel. However, not having a spot welder or even an arc welder, and not having...
  3. 1965 Mustang Cross Measuring engine compartment

    Classic Tech
    I'm looking for cross measurements on the engine compartment on early Mustangs that are in good body shape. I cross measured from the passenger side were the cowl meets the apron extension to the front and got 55 1/2" and 56 1/4" from the driver side to the front. I also measured 41 1/2" from...
  4. 5.0 parts list updated*

    5.0L Talk
    List of parts I will be ordering very soon any suggestions? Edelbrock 60379 heads Polished edelbrock rpm II intake bbk 75 mm throttle body 73 mm maf 24 lbs injectors 255 lph fuel pump bbk pressure regulator bbk fuel pressure gauge msd distributor msd blaster coil crane 1052 roller...
  5. Engine Bay Cleaning

    2005-2010 Mustang Talk
    All i did was take a rag poured some mineral spirit on it and it took it off immediately, i didnt have to let it sit or anything. No Fumes ethier. Then grabbed a wet rag and wiped the loose dirt off.
  6. 1966 mustang engine compartment Help?

    Classic Tech
    I am looking for exact deminsions for the engine compartment on a 1966 mustang. I am replacing the cowl and 2 frount aprons due to prior damage so I cant simply measure before removal. Help would be great. Thanks Paul
Top