Ford Mustang Forum banner
Cancel

Search Results for ‘floor pans’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results

Search Tags

1965 1966 1967 1968 2.3 2005 2006 2007 2011 289 3.8 302 4.6 5.0 alternator american iron cmc mustang automatic battery brakes bullitt cai cam cj pony parts classic clutch cobra cold air intake conversion convertible coupe electrical engine engine swap exhaust flowmaster ford ford gt fox body foxbody fuel fuel pump gears gt500 headers headlights heads hood horsepower idle ignition install intake interior introduction leak lights mach 1 manual misfire mods muffler mustang mustang car show mustang gt noise oil paint parts performance power problem problems radio rear end rebuild rims roush s197 sale sct shelby sn95 springs starter steeda supercharger suspension swap throttle body timing tires transmission tune tuner turbo v6 mustang video videos wheels wiring
  1. Classic Tech
    So I know there are millions of posts about the cowl rust but I see prices and work vary from post to post from 2004 up to now. I have a 1966 Mustang Coupe. Water leaks into it and im 99% sure its from the cowls that everyone has the issues with. Im in north georgia (cobb county), does anyone...
    1966 mustang coupe atlanta cowl rust floor pans rustomod
  2. 5.0L Tech
    I have a 93 that has a couple holes in the floor pans. I have only looked at the driver side and only half of it. I was wonder if i replaced only driver side pan besides the from seat platform do i need to cut out the rest of the pan or could i lay it over the old pan.I am not too deep into it...
    floor panels floor pans floor pans rust floor repairs
  3. Classic Tech
    Hello all, I am restoring a 66 Mustang Convertible. This may be a stupid question but I need an honest answer. I don't want seams in the floor pan so I intend to put in a complete floor pan. My question is this: without the support of a roof, like on a coupe, with the floor panels removed is...
    convertibe floor pans restoration
  4. Introduce Yourself | No Tech Questions Please!
    Good afternoon. I have joined to find advice and tips. I have decided to restore a 1965 convertible that was given to me from my grandfather. I have a lot of work ahead of me. I have taken out the seats, seat belts, and carpet. My main goal is to get the floor pans replaced to start off and go...
    floor pans
  5. Classic Tech
    I will have to replace some/most of the floor pans in my 6 coupe. My question is, do the new pans get spot welded in or does the whole seam get welded in?
    floor pans
  6. 5.0L Talk
    ok i have a 88 gt that im starting to restore im gonna start by installing new floor pans but i have never done this do you guys have any pointer on were to start
    88 gt floor pans fox body
  7. SouthEast
    I was wondering if any of you would know a decent place to get floorboards repaired in the state of Florida. It's on a 1990 Mustang GT the driver side floor board definitely needs repaired as it has rusted thru in several spots. Thanks for any help you may have to offer.
    floor pans floor repairs
  8. Classic Talk
    I just recently started restoration on my 1966 mustang and i found some small rust spots dime sized on the floor pans. My question is would it be better if i just replace them or is it possible to repair them? Any input on this subject is greatly appreciated.
    1966 floor pans mustang rust repair
1-8 of 8 Results
Top