Ford Mustang Forum banner
Cancel

Search Results for ‘frozen’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results

Search Tags

1965 1966 1967 1968 2.3 2005 2006 2007 2011 289 3.8 302 4.6 5.0 alternator american iron cmc mustang automatic battery brakes bullitt cai cam cj pony parts classic clutch cobra cold air intake conversion convertible coupe electrical engine engine swap exhaust flowmaster ford ford gt fox body foxbody fuel fuel pump gears gt500 headers headlights heads hood horsepower idle ignition install intake interior introduction leak lights mach 1 manual misfire mods muffler mustang mustang car show mustang gt noise oil paint parts performance power problem problems radio rear end rebuild rims roush s197 sale sct shelby sn95 springs starter steeda supercharger suspension swap throttle body timing tires transmission tune tuner turbo v6 mustang video videos wheels wiring
  1. Classic Tech
    Does anyone have any advice on how to fix a Autolite 1100 1v carburetor with a power valve assembly that gets stuck in the up/depressed position? details/hints: I have my dad's 67 Mustang with 200 six and rebuilt the carburetor in 2009, 2 time in 40 years. The problem is that there is no fuel...
    autolite 1100 frozen power valve assembly stuck
  2. V6 Tech
    Hi All, I need some advice from brake experts here. I had replaced my pads earlier, but then found a few weeks later that my front drivers side pads are thinner and there's excessive brake dust on that side. So I replaced the pads again and lubricated the slide pins but now that doesn't seem to...
    brake calipers frozen pads stuck
  3. 2005-2010 Mustang Talk
    To start off I don't think its "frozen" cuz pf the cold because my case seems different from everyone elses i've read. I have an Automatic tranny. I put on the Ebrake and jacked up my car today to do an oil change. By the time I was done and everything I went to put the Ebrake down. However...
    e brake ebrake frozen stuck
1-3 of 3 Results
Top