Ford Mustang Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. 5.0L Tech
    I have a 1993 Mustang GT that I have recently swapped out the EFI in favor of a Holley Sniper EFI setup. My question is how can I connect the factory fuel lines near the passenger fender well to -6 AN? I have the -6 AN lines already but just need to adapt the factory steel fuel lines. I have...
  2. 5.0L Tech
    I am putting my 90 hatch back together and I am doing it right this time around. I have been wanting to put a fuel cell in and run new fuel lines. I have no clue on what is right and wrong when it comes to this. What is the recommended set up for a fuel cell such as location and size? I know it...
  3. 2.3L Tech
    so i finally get to put together my 89 fox-body hatchback when i went to put the fuel filter in i noticed that there were only two fuel lines that went to that end of the car but how do i hook up the filter and the pump on two lines?
  4. 5.0L Tech
    I just purchased a 1987 LX 5.0 and it has a fuel delivery issue (I think). IT will start after having to pump the fuel pedal multiple times until it tries to start... then I turn the key off and try to start it again. It starts right up and runs for about 30 seconds at which point it sputters...
  5. 2005-2010 Mustang Talk
    I recently installed a UCI on a 2010 Mustang GT. While I was under the car I noticed this (in the picture). For orientation, the fuel line is in the center, the exhaust is on the left, the panhard brace is bottom/left, to the right I think is the spare tire well. As you can see the...
  6. 5.0L Tech
    I am converting my 84GT (carbed) to an EFI setup from a 93GT. Can I use the stock 84 fuel tank and lines the way they are, and just add an inline fuel pump?
  7. 5.0L Tech
    Hello. I was wondering if anyone could answer this question that I had. I recently had my front frame rails fixed and the guy cut my fuel lines that go from the fuel rail to the ones on the chassis. I was wondering how I could fix this because those lines are very hard to bend back together...
1-7 of 7 Results
Top