Ford Mustang Forum banner
Cancel

Search Results for ‘hard to turn’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-1 of 1 Results

Search Tags

1965 1966 1967 1968 2.3 2005 2006 2007 2011 289 3.8 302 4.6 5.0 alternator american iron cmc mustang automatic battery brakes bullitt cai cam cj pony parts classic clutch cobra cold air intake conversion convertible coupe electrical engine engine swap exhaust flowmaster ford ford gt fox body foxbody fuel fuel pump gears gt500 headers headlights heads hood horsepower idle ignition install intake interior introduction leak lights mach 1 manual misfire mods muffler mustang mustang car show mustang gt noise oil paint parts performance power problem problems radio rear end rebuild rims roush s197 sale sct shelby sn95 springs starter steeda supercharger suspension swap throttle body timing tires transmission tune tuner turbo v6 mustang video videos wheels wiring
  1. Classic Tech
    ok i am rebuilding a 1965 289, new speed pro pistons, the crank has been grinded and rebalanced, rods were cleaned and honed out, block bored .030 over we have built all the bottom end back and it is really hard to turn we know the pistons are tight, new bearings, and assembly lube on everything...
    connecting rods engine rebuild hard to turn
1-1 of 1 Results
Top