Search Results for ‘headgasket’

Hey guys, so I'm trying to replace a blown headgasket and in order to get the head off I have to take the exhaust manifold off and the brake booster is blocking the last 2 bolts on the exhaust. So I have the brake completely unbolted and just sitting in the firewall, but I have barely have any...

It's an 1989 mustang that's 99 cobra swapped it was a crate motor from Ford trans has never even been off it's 100% a stock motor headgasket went after motor was over heated and sat in a heated garage since 2005. What's the chance that the bottom end is rusted and pitted and would need bored. I...

Hello again I am about to attempt to replace all of the gaskets on the top half of my motor. Well and painting my intake, heads, headers etc. The only one Im not attempting to do is the oil pan gasket. It looks like a pain in the ***. Do I have to remove the dist? Also can I hang up my fuel...

whats the easiest way to get water out of the engine block from a blown headgasket? im talking about the little holes around the cylinder head. thanks! :wavey

i have a 2003 mustang gt with a few mods, when i first start the car i smell a LITTLE oil buring, how ever once the car get warmed up it is fine, but once warm and i pull up some where to idle(drvie thru!) it smokes white smoke. or if i rev the car up the once it is reving down it will put out a...

My dad has a 1995 mustang v6 (that i would like to drive in future) that he took to mechanic he said there was headgasket failure. My question is what is the best way to fix this problem and keep it from happening. Possible solutions i thought of (remember i want the low cost option of fixing...

Hi everybody. So I am 90% sure my head gasket is blown. Car runs well but loses coolant rather quickly. (about 200-250ml @ 20 minutes of idle). Also when started up i get a puddle under my exhaust pipe. (not good) The good news i guess is there doesn't seem to be any water in the oil from what i...